Meanwhile I have VDSL 100. I gamble and watch TV that is IPTV. I also stream on Netflix. But I'm the only participant in the house who does this. Then the VDSL 100 line is sufficient or the 250 should be available.
So far I have had the problem with the 100 line that I can only operate the line with interference immunity, as interference creeps in on the line again and again. In addition, I'm worried that the 250 will not cause even more interference than the 100 now.
You can best judge for yourself whether 100 Mbit / s is fast enough.
Do you now and then come into a situation where you have the impression that the speed is not enough?
Since up to 12.5 megabytes of download per second are possible with a 100 megabit line, you can run 18 full HD streams side by side at the same time and everything runs smoothly! Or 4 times 4K Netflix streams without problems! So the 100 line is easy enough for rich people. But if the 250 megabits line should be insignificantly more expensive, then just treat yourself. You can then tap into 3 full HD streams on 10 devices at the same time. That gives a lot of traffic.
Yes, but as I said, the problem is that the 100 line keeps recording errors. I think the line is something at the limit. 270 meters distance now. The question is whether the 250 will increase the error rate.
Yes, but as I said, the problem is that the 100 line keeps recording errors. I think the line is something at the limit. 270 meters distance now. The question is whether the 250 will increase the error rate.
Unfortunately I can't see clairvoyance.
But of course the danger is there.
Is the connection with us? Which devices are in the network? A change to SVDSL 250 can bring about improvement, but I would first clarify and remedy the cause of the malfunctions. It doesn't help if things still don't run smoothly.
The connection is with the telekom. But I already had 7 technicians and everything is good so far. I have Fritz! Take Box 7590. And so far it only runs with interference immunity, which does not cause any deterioration based on the performance. There are always errors S that are recorded and DTU errors. The signal-to-noise ratio can drop from 12db to 6-7db. So far, VDSL 100 is the highest I can have. But the Telekom is laying new fiber optics to the distributors. So I think that the 250 could soon be there too. As I said, emphasis on could. So the only question that came up was whether the 250 runs more stably, if available, or whether the error rate of the DTU and error ES can increase? Just asked in general so far.
So as I said so far, it works. But mistakes can never be completely prevented with a line length of 270m and a line that is from the 70s:-)
Devices that otherwise draw are a TV with the Bagenta Receiver, 2 PCs and mobile devices. So the question arose whether the 100 line would be sufficient for the future. Because what if I actually use that alone?
It doesn't necessarily have to be the old line. Such disorders can have various causes.
For example, powerline adapters tend to interfere with the DSL signal because they work in the same frequency range.
Tonight you could disconnect all devices from the router and completely switch off everything that is in the same room with the router and pull the plug.
Also make sure that there are no cables near the router or the TAE socket with the exception of the cable with which the router and the socket are connected.
If the FritzBox then registers far fewer errors at night than usual, then the source of the interference is probably in your house.
At that time you guessed it was with the neighbors or power cables. Powelan has everything dismantled his house. Repeater only. But hurry up. I think a certain amount of mistakes is normal at the moment when you consider who is pulling everything in Corona ;-)
So so far it was enough.
